Mycom UPS52-113CE Industrial Refrigeration Module

Description

3. Key Technical Specifications

4. Product Introduction & Supply Chain Strategy

The Mycom UPS52-113CE is a specialized module used within Mycom industrial refrigeration compressor packages. It supports reliable operation of screw or reciprocating compressors in process cooling, cold storage, and gas-compression applications where continuous uptime is essential.

Securing this module as New Surplus protects Total Cost of Ownership on installed Mycom systems. Genuine new-surplus units eliminate the risk of premature failure associated with refurbished electronics or power components. Because detailed public availability is limited, holding 1–2 units of buffer stock is the practical approach to avoid extended downtime and high emergency procurement costs.

UPS52-113CE

UPS52-113CE

5. Installation & Configuration Guide

Stage 1: Pre-Installation (Prep & Safety)
Perform full lock-out/tag-out on the compressor package, including main power, control power, and refrigerant circuits as required. Photograph existing wiring, terminal positions, and any configuration settings. Confirm the replacement is New Surplus and free of damage.

Stage 2: Removal
Isolate and discharge residual energy. Disconnect all power, signal, and control wiring, labeling each conductor. Unbolt and extract the module carefully, supporting its weight to protect connectors and mounting points.

Stage 3: Installation (Clone & Seat)
Seat the new UPS52-113CE into the package chassis, aligning mounting holes and connectors. Reconnect wiring exactly as documented, observing polarity and torque specifications. Restore any original jumpers or settings.

Stage 4: Power-On & Testing
Restore power in a controlled sequence. Verify correct voltages, communication with the package controller, and absence of fault indications. Perform a functional check of the associated compressor functions before returning the system to automatic operation.

6. Firmware/Software Versions & Upgrade Notes

Any firmware resides in the module or associated package controller and is typically managed at the system level. Retain the original configuration parameters.

Do not mix firmware revisions across redundant or parallel packages without full validation. Document the existing software version and parameter set before replacement. Avoid firmware changes during a simple hardware swap unless the entire package is re-commissioned by qualified personnel.

7. Frequently Asked Questions (FAQ)

Q: Is this truly New Surplus or refurbished?
A: Brand New Surplus only. Original manufacturing, unused, with zero operating hours.

Q: Why is the price higher than used units?
A: Pricing reflects genuine New Surplus inventory. It avoids the reliability risk of refurbished modules that can fail under continuous industrial duty while remaining below typical emergency OEM pricing.

Q: Is the UPS52-113CE still in active production?
A: Availability is specialized/limited. Strategic buffer stock of 1–2 units is recommended for plants operating Mycom refrigeration packages that use this module.

Q: Can the module be hot-swapped?
A: No. Always follow full lock-out/tag-out and package-specific isolation procedures. Live replacement risks equipment damage and personnel injury.

Q: Will the new module require re-programming of the compressor package?
A: In most cases the original parameters can be retained. Perform a full functional test of the package before returning it to production service.

Q: What warranty is provided?
A: Standard 1-year warranty covering manufacturing defects. Visual and basic functional verification is performed prior to shipment.

Q: Do you support last-time-buy or multi-site consolidation for Mycom components?
A: Yes. For facilities running multiple Mycom packages we can coordinate consolidated New Surplus holdings to minimize total carrying cost while protecting against stock-outs.