Description
Key Technical Specifications
- Part Number: KJ3241X1-BA1 (alternate ordering codes: 12P2506X032, 12P2506X042, 12P2506X062, 12P2506X072)
- Product Type: DeltaV M-Series Serial Interface Card
- Local Bus Power: 12 VDC at 300 mA
- Serial Ports: 2 independently configurable ports (RS-232 or RS-485, half/full duplex)
- Baud Rates: 300 to 115,200 bps
- Ambient Temperature Range: −40 °C to +70 °C
- Relative Humidity: 5 to 95% non-condensing
- Airborne Contaminants: ISA-S71.04–1985 Class G3
- Shock: 10 g half-sine wave for 11 ms
- Vibration: 1 mm p-p (2–13.2 Hz); 0.7 g (13.2–150 Hz)
- Hazardous Area Ratings: II 3G Ex nA nC IIC Gc; FM12ATEX0090U; IECEx FMG 12.0035U
- IP Rating: IP20
- Removal/Insertion: Must de-energize system power before removal/insertion (D4 key position)
- Typical Assembly: Used with KJ3003X1-EA1 terminal block in VE4006P2-style serial interface assemblies
Product Introduction
The Emerson KJ3241X1-BA1 is a DeltaV™ M-Series serial interface card that provides two independently configurable serial ports (RS-232 or RS-485) for integrating field devices into a DeltaV DCS. It’s commonly deployed in VE4006P2-type assemblies alongside the KJ3003X1-EA1 terminal block to support Modbus RTU and other serial-driver applications.
This card is chosen for its dual-port flexibility, wide temperature rating (−40 to +70 °C), and hazardous-area certifications, making it suitable for process plants that need reliable serial comms in demanding environments. In the field, you’ll see it handling analyzer interfaces, legacy PLC links, and serial instrument gateways where Ethernet isn’t an option.

KJ3241X1-BA1

KJ3241X1-BA1
Troubleshooting Quick Reference
| Symptom | Possible Cause | Relevance to this Part | Quick Check Method | Recommendation |
|---|---|---|---|---|
| No comms on either serial port | Local bus power missing or out of spec | ✅ High | Measure 12 VDC at card edge/backplane with multimeter; verify carrier power status | Check carrier PSU and fuses; reseat card after power-down |
| Port 1 works, Port 2 dead | Port misconfigured in DeltaV driver; wrong RS-232/RS-485 selection | ✅ High | Review DeltaV serial driver config (port mode, baud, parity); compare to device specs | Reconfigure driver to match field device; test with loop-back or serial tester |
| Intermittent timeouts on RS-485 | Wiring errors, missing termination, or ground loops | ✅ High | Inspect A/B wiring; measure termination (120 Ω across A-B at ends); check ground potential | Add/verify end-of-line terminators; ensure single-point shield grounding |
| Card not detected by DeltaV controller | Slot fault; card inserted with power on; backplane issue | ❌ Medium (carrier/backplane) | Check DeltaV diagnostics for slot faults; inspect carrier LEDs | Always power down before inserting/removing cards; try known-good slot |
| High error rate on serial link | Baud/parity mismatch; noise on cable run | ✅ High | Capture error counters in driver; use serial tester to verify framing | Match baud/parity/stop bits; shorten cable or add isolated repeater if noisy |
If you’re stuck, pull a screenshot of the DeltaV serial driver config, a photo of the wiring at the terminal block, and the diagnostic buffer, then send those to support.
Frequently Asked Questions (FAQ)
Q: Is the KJ3241X1-BA1 hot-swappable?
A: No. Emerson specifies this card must be removed/inserted only with system power de-energized (D4 key position). Plan a short maintenance window.
Q: What serial protocols does this card support?
A: The hardware supports RS-232 and RS-485; protocol support (Modbus RTU, Data Highway Plus, etc.) comes from the DeltaV serial driver configuration.
Q: Is this new or refurbished?
A: We supply this as New Original / New Surplus unless otherwise noted. Factory packaging and suffix codes (12P2506X032/042/062/072) may vary by lot.
Q: Can I use this without the KJ3003X1-EA1 terminal block?
A: No. For VE4006P2-style assemblies, the KJ3241X1-BA1 pairs with the KJ3003X1-EA1 terminal block to provide field wiring access.
Q: What’s the lead time?
A: Typical ship time is 3–5 working days from stock. If you need a specific delivery date, tell us up front so we can stage it.
Q: What warranty do you offer?
A: 1-year warranty against DOA and functional defects. We’ll replace or refund if it fails under normal use within that period.
Q: Why is this cheaper than buying direct from Emerson?
A: This is surplus channel stock — genuine OEM hardware, but sourced via secondary distribution. Same part number, often with original factory labels and packaging.

WhatsApp: +86 16626708626
Email:
Phone: +86 16626708626