WhatsApp: +86 16626708626
Email: 
Phone: +86 16626708626Description
Key Technical Specifications
- Manufacturer: GE
- Model: DS3800NUVA1C1B
- Series: Mark IV
- Product type: UV relay board
- Application: Gas turbine control system
- Function: UV relay circuit interface
- Compatibility: Exact suffix match required
- Condition: New surplus or tested surplus
- Obsolescence: Legacy Mark IV spare part
- Replacement note: Verify board revision and connector layout before installation
Product Introduction
GE DS3800NUVA1C1B is a Mark IV UV relay board used in legacy GE turbine control systems. It is a printed circuit board built for industrial control and relay interface duties inside the Speedtronic Mark IV platform.
This part is typically bought for exact replacement work where the installed system must stay online. The key check is suffix and revision accuracy, because Mark IV boards can look similar while still being wrong for the cabinet.
Troubleshooting Quick Reference
| Symptom | Possible Cause | Relevance to This Part | Quick Check Method | Recommendation |
|---|---|---|---|---|
| UV relay function missing | Failed relay board or upstream command issue | ✅ High | Check command input and relay output state with a meter | Verify upstream control first, then replace if the board does not respond |
| No LEDs or dead board | Missing rack power or board failure | ✅ High | Measure supply voltage at the connector | Check power and fuse status before swapping the board |
| Intermittent relay operation | Loose connector or aging solder joints | ✅ Medium | Inspect connector seating and board discoloration | Reseat and inspect before ordering a replacement |
| Board not accepted after install | Wrong suffix or revision mismatch | ✅ High | Compare the old label to DS3800NUVA1C1B exactly | Match the full part number before installation |
| System alarm persists after swap | External wiring or field device issue | ❌ Low | Trace wiring from the board to the field circuit | Do not assume the board is bad until the loop is checked |
| Works in another rack but not this one | Rack revision or slot compatibility issue | ✅ Medium | Test in a known-good Mark IV rack | Confirm cabinet revision and slot mapping first |
- DS3800NUVA1C1B
Frequently Asked Questions
Q: What is the GE DS3800NUVA1C1B used for?
A: It is a GE Mark IV UV relay board used in legacy turbine control systems.
Q: Is this part still available?
A: Usually it is found as new surplus or tested surplus, not current factory production. Stock is limited because it is a legacy Mark IV item.
Q: Can I replace another DS3800NUVA board with this one?
A: Only if the full suffix and revision match your original unit. Do not assume interchangeability from the base model alone.
Q: Is it plug-and-play?
A: Not always. Legacy GE boards need the correct rack, connector layout, and board revision, or you can end up chasing avoidable faults.
Q: Why is surplus cheaper than factory stock?
A: Because it comes from older inventory rather than active production. The lower price reflects sourcing and age, not a lower functional standard.
Q: What should I verify before ordering?
A: Confirm the full model number, suffix, board label photo, rack type, and cabinet wiring arrangement. That prevents most replacement mistakes.
Q: Is this board refurbished or new surplus?
A: Listings vary by seller. New surplus means unused legacy stock, while refurbished means it was tested and restored before shipping.
