WhatsApp: +86 16626708626
Email: 
Phone: +86 16626708626Description
Key Technical Specifications
- Model: IS200VCMIH1B
- Brand: GE
- Series: Mark VI
- Product type: VME control module
- Application: Industrial turbine control and automation
- Interface: VME backplane
- Form factor: Board-level module
- Condition: New Surplus / Tested
- Compatibility: Verify against exact Mark VI rack and firmware revision
- Installation note: Match board revision and rack slot requirements before replacement
Product Introduction
GE IS200VCMIH1B is a Mark VI VME control module used in industrial control and turbine system cabinets. It serves as a rack-mounted board for GE automation hardware where exact part matching matters.
Buyers choose this part when they need a direct replacement for an existing GE Mark VI installation. Confirm rack compatibility, board revision, and firmware requirements before install to avoid comms faults or startup issues.
Troubleshooting Quick Reference
| Symptom | Possible Cause | Relevance to this Part | Quick Check Method | Recommendation |
|---|---|---|---|---|
| No rack communication | Backplane issue, wrong slot, failed board | ✅ High | Verify slot power, reseat board, inspect backplane LEDs | Replace the module only after confirming rack power and slot integrity |
| Controller does not boot | Board fault or firmware mismatch | ✅ High | Check diagnostic LEDs and startup logs | Compare revision and firmware against the original unit |
| Intermittent faults after swap | Revision mismatch or poor seating | ✅ High | Inspect edge connector, confirm board revision, check cabinet vibration | Reseat and verify exact replacement model |
| No effect from control commands | Upstream logic or I/O issue | ❌ Low | Check adjacent modules and controller status | Trace the fault outside this module first |
| Overheating in cabinet | Poor airflow or overloaded rack | ❌ Low | Measure cabinet temperature and rack loading | Improve cooling before blaming the board |
| System alarms after power-up | Configuration mismatch | ✅ High | Review configuration files and hardware map | Restore original configuration and verify hardware definition |
Contact technical support with photos of the board, rack, LED status, and diagnostic logs if the fault is still unclear.
- IS200VCMIH1B
- IS200VCMIH1B
Frequently Asked Questions
Q: Is IS200VCMIH1B a direct replacement?
A: Usually yes, but only if the revision, rack type, and system firmware match. GE Mark VI hardware can be picky, so verify the exact suffix before ordering.
Q: Is this module hot-swappable?
A: No, treat it as a power-down replacement unless your site documentation says otherwise. Pulling it live can damage the backplane or the board.
Q: Will my configuration stay intact after replacement?
A: The board itself does not store your whole system setup. In most cases the configuration lives in the controller or engineering files, so back those up before swap.
Q: What condition is this part in?
A: This listing is New Surplus / Tested. That means it is not factory fresh, but it should be visually inspected and function-checked before shipment.
Q: Why is it cheaper than a factory-new unit?
A: Surplus stock comes from excess inventory, decommissioned systems, or unused spares. The lower price reflects sourcing, not a claim that the part is newer than it is.
Q: What should I verify before installation?
A: Check board revision, rack compatibility, connector condition, and cabinet power quality. A mismatch on any of those can look like a bad module when the real problem is elsewhere.
Q: How do I know it is actually bad?
A: Look for failed boot LEDs, missing rack communication, or repeated diagnostic alarms after you confirm power and seating. If those checks pass and the fault stays with the board, replacement is likely justified.
