WhatsApp: +86 16626708626
Email: 
Phone: +86 16626708626Description
Key Technical Specifications
- Function: Physical protective cover for KCM keypad display door and CPU housing
- Voltage Compatibility: 115/230 VAC KCM systems
- Category: Safety Systems — Safety Accessory
- Weight: 2.53 lbs
- Part Type: Non-electronic — passive enclosure/cover component, no firmware or configuration involved
- ⚠️ Exact Dimensions, Mounting Hardware, Material Composition: Not confirmed in this pass — verify against the K-Tron KCM installation manual or the specific unit’s fit against your existing controller housing before ordering.
Product Introduction
The K-Tron 0000025153 is a keypad display and CPU door cover for the KCM continuous weigh feeder controller, rated for 115/230 VAC system configurations. It’s a protective enclosure component, not an electronic assembly — its job is physically shielding the keypad display and CPU compartment from dust, debris, and incidental contact in a plant environment.
Plants running legacy K-Tron KCM controllers replace this part when the original cover is cracked, missing hardware, or damaged from handling — not because of any electrical fault, since the cover carries no active circuitry of its own.
Troubleshooting Quick Reference
Since this is a passive cover rather than an active electronic part, there isn’t a meaningful electrical fault-diagnosis table for it. The honest guidance here:
| Symptom | Possible Cause | Relevance to this Part | Quick Check Method | Recommendation |
|---|---|---|---|---|
| Cover cracked, warped, or missing mounting points | Physical damage or age-related material fatigue | ✅ High | Visual inspection of the cover itself | Replace the cover — this is a mechanical wear item |
| Keypad display faults or CPU faults | Electronic fault inside the KCM controller | ❌ Low | Diagnose the KCM controller’s actual electronics | This cover has no bearing on internal electronic faults |
| Door won’t close/latch properly | Cover misalignment or damaged latch hardware | ✅ High | Check latch and hinge condition on the cover | Confirm hardware fit before assuming controller-side issue |
If you’re troubleshooting an actual KCM display or CPU fault, that’s a controller-level issue — this cover replacement won’t resolve electronic faults, only physical enclosure damage.
0000025153
0000025153
Frequently Asked Questions (FAQ)
Is this an electronic part, or just a physical cover?
Just a physical cover — it protects the keypad display and CPU compartment door. There’s no circuitry, firmware, or configuration involved in this part at all.
Will replacing this fix a display or CPU fault on my KCM controller?
No. If your keypad display or CPU itself is faulting, that’s an internal electronics issue on the controller — this cover only addresses physical damage to the enclosure, not what’s inside it.
Is this still available new from K-Tron/Coperion?
No, it’s discontinued by the manufacturer. What’s available is surplus stock — either never-used in original or repackaged condition, or refurbished. Confirm which condition you’re getting, since pricing varies significantly between the three.
Does the voltage rating (115/230 VAC) mean this cover has electrical components?
No — the voltage rating reflects which KCM system variant this cover is designed to fit, not an electrical spec of the cover itself. It’s matched to the controller’s voltage configuration for correct fit, not because the cover carries power.
Do I need any special tools or hardware to install this?
Confirm mounting hardware compatibility with your existing KCM controller housing before ordering — legacy enclosure parts sometimes require hardware that isn’t included in a bare cover replacement.
Why is this priced significantly higher than a typical cover part?
Discontinued safety accessory parts for legacy weigh feeder controllers often carry premium pricing simply due to scarcity, not complexity. If cost is a concern, ask your supplier whether a refurbished unit meets your needs at a lower price point than never-used stock.
