WhatsApp: +86 16626708626
Email: 
Phone: +86 16626708626Description
Key Technical Specifications
- Manufacturer: SAM Electronics
- Part number: AG 6022-SD102-001
- Product type: Display module / electronic board
- Application: Shipboard automation and operator interface
- System fit: Must match the installed SAM Electronics platform
- Revision control: Verify board revision before purchase
- Connector interface: Confirm pinout and mating hardware
- Condition: New Surplus or Refurbished, depending on inventory
- Availability: Legacy stock only
- Installation note: Compare the old board label and connector layout before swap
Product Introduction
SAM Electronics AG 6022-SD102-001 is a marine display module or PCB assembly used in legacy shipboard automation systems. It is the kind of part you buy when the installed platform must stay intact and the replacement has to match the original hardware.
For this type of legacy marine electronics, the exact part number, revision, and connector style matter more than appearance. Verify compatibility against the installed system before ordering.
- 6022-SD102-001
Troubleshooting Quick Reference
| Symptom | Possible Cause | Relevance to this Part | Quick Check Method | Recommendation |
|---|---|---|---|---|
| No screen activity | No supply voltage or failed display board | ✅ High | Measure input voltage at the board terminals with a multimeter | Check PSU, fuses, and wiring first |
| Backlight on, no image | LCD panel fault or signal issue | ✅ High | Inspect signal lines and compare with known-good output | Replace only after confirming signal is present |
| Flickering display | Loose connector, poor grounding, or unstable supply | ✅ High | Reseat connectors and monitor voltage under load | Check cabling and ground before swapping the board |
| Wrong or scrambled characters | Data mismatch or damaged interface board | ✅ Medium | Compare revision and interface settings with the original unit | Confirm compatibility before replacement |
| Panel not recognized | Revision mismatch or communication failure | ✅ High | Check part label and system diagnostics | Match the exact revision and system version |
| Intermittent shutdown | Power dip or thermal issue | ✅ Medium | Monitor supply voltage and enclosure temperature | Verify cooling and PSU health first |
| Display works after tap or reseat | Oxidized contacts or loose mount | ✅ Medium | Inspect pins and clean mating connectors | Service contacts before replacing hardware |
Contact technical support with photos of the label, connector side, and any diagnostic logs if the fault is still unclear.
Frequently Asked Questions
Q: Is AG 6022-SD102-001 a display board?
A: Based on the part naming and legacy marine listings, it is commonly handled as a display module or PCB assembly for operator interface use.
Q: Is this an exact replacement?
A: Only if the part number, revision, connector layout, and host system match. Legacy marine hardware is picky, and close-looking parts can still be incompatible.
Q: Is it new or refurbished?
A: Stock may be new surplus or refurbished depending on availability. The condition should be stated clearly before sale.
Q: Can I install it without changing software?
A: Not always. If the board is tied to a specific control platform or screen firmware, confirm the system revision first.
Q: Why is it cheaper than OEM support stock?
A: Because it is usually sourced from surplus or reclaimed inventory, not current production. That lowers cost, but it raises the importance of verification.
Q: Is it hot-swappable?
A: Do not assume so. For marine control hardware, power down unless the OEM documentation explicitly allows live replacement.
Q: What should I verify before ordering?
A: Match the exact part number, board revision, connector style, and the installed platform. That prevents most replacement mistakes.
