WhatsApp: +86 16626708626
Email: 
Phone: +86 16626708626Description
Key Technical Specifications
- Model: IC3600EPSA1
- Brand: GE
- Series: Speedtronic Mark I & II
- Function: Voltage regulator circuit board
- Application: Gas turbine control and regulation
- Status: Obsolete / discontinued by manufacturer
- Mounting: Board-level replacement for existing control rack
- Condition: New Surplus or Refurbished, depending on stock
- Traceability: Verify serial and board revision before purchase
- Compatibility: Confirm exact Mark I/II application before installation
Product Introduction
GE IC3600EPSA1 is a voltage regulator circuit board used in GE Speedtronic Mark I and Mark II control systems. It serves turbine control applications where board-level voltage regulation is part of the legacy system architecture.
This part is typically sourced as a replacement for aging installed equipment, so revision matching matters. Verify the exact board code, rack position, and system compatibility before ordering.
Troubleshooting Quick Reference
| Symptom | Possible Cause | Relevance to This Part | Quick Check Method | Recommendation |
|---|---|---|---|---|
| Regulated voltage is unstable | Failed components on the regulator board | ✅ High | Measure output stability at the expected test points with a meter | Replace the board if supply inputs are correct |
| Turbine control alarms appear at startup | Board fault, bad seating, or upstream power issue | ✅ High | Inspect rack seating and check alarm codes in the controller | Reseat the board and verify power first |
| No output from the regulation path | Open circuit, blown fuse, or failed board | ✅ High | Check input power and continuity through the board path | Confirm supply and fuse health before replacement |
| Intermittent operation after warm-up | Aging components or thermal stress | ✅ High | Run the system under load and monitor for drift or reset | Replace if the fault repeats under temperature rise |
| Board appears physically normal but system still faults | Hidden component degradation or compatibility issue | ✅ High | Compare board revision and system configuration with the original | Match the exact revision before swapping |
| Other cards in the rack fault too | Rack power or backplane issue, not this board | ❌ Low | Measure rack supply and inspect backplane connections | Fix the rack-level issue first |
If you are stuck, send photos of the board, rack slot, and diagnostic logs to technical support.
- IC3600EPSA1
- IC3600EPSA1
Frequently Asked Questions
Q: What is the IC3600EPSA1 used for?
A: It is a GE Speedtronic Mark I/II voltage regulator circuit board used in legacy turbine control systems.
Q: Is this part still manufactured?
A: No, it is an obsolete model. That is why most available stock is surplus, refurbished, or pulled from service.
Q: Can I replace it with a similar GE board?
A: Sometimes, but I would not assume interchangeability. The board revision and system configuration have to match the original installation.
Q: Is it hot-swappable?
A: No. Power down the system before removal unless the OEM procedure for your exact rack says otherwise.
Q: Why is the price lower than a factory-new part would be?
A: Because the part is discontinued and usually sold from surplus or tested recovered inventory. Lower price is normal, but only if the seller is clear about condition and testing.
Q: What should I check before ordering?
A: Confirm the full model number, board revision, rack slot, and the exact GE Speedtronic Mark I/II application. That avoids the common mistake of buying a close match that does not function in the installed system.
Q: What condition should I ask for?
A: Use New Surplus, New Original, or Refurbished (tested). For obsolete GE boards, clear condition language matters more than marketing claims.
