WhatsApp: +86 16626708626
Email: 
Phone: +86 16626708626Description
Key Technical Specifications
- Model: IS200BPPBH2BMD
- Brand: GE
- Series: Mark VI turbine control
- Function: Analog I/O board / control board module
- Application: Gas turbine and industrial control systems
- Status: Obsolete / legacy platform part
- Mounting: Rack or slot-mounted board assembly
- Condition: New Surplus or Refurbished, depending on stock
- Compatibility: Verify exact Mark VI system revision before installation
- Traceability: Confirm board suffix and revision code before purchase
Product Introduction
GE IS200BPPBH2BMD is a Mark VI control board used in turbine automation and related industrial control systems. It handles analog I/O and signal processing functions inside the GE Mark VI architecture.
This part is usually bought as a replacement for aging installed systems, so revision matching is critical. Check the full suffix, rack position, and site configuration before ordering.
Troubleshooting Quick Reference
| Symptom | Possible Cause | Relevance to This Part | Quick Check Method | Recommendation |
|---|---|---|---|---|
| Analog signals are missing | Board fault, wiring issue, or upstream transmitter failure | ✅ High | Measure signal at the terminal block and compare to the controller reading | Verify field wiring before replacing the board |
| Controller shows I/O fault | Bad board seating, failed module, or rack power problem | ✅ High | Reseat the card and check rack supply voltage | Check the rack first, then the board |
| Intermittent process values | Loose connector, ground noise, or aging component | ✅ High | Inspect connectors and watch values while gently flexing the harness | If the fault follows the module, replacement is likely |
| Board does not initialize | No backplane power or internal board failure | ✅ High | Measure rack voltage and inspect status LEDs if present | Confirm power and rack health before swapping |
| Other cards in the rack also fault | Backplane or system power issue | ❌ Low | Check rack PSU and backplane continuity | Fix the rack-level issue first |
| Incorrect scaling or bad channel values | Configuration mismatch, not hardware failure | ⚠️ Medium | Compare controller configuration and I/O mapping with the original unit | Recheck setup before ordering a replacement |
If you are stuck, send photos of the board, rack slot, and diagnostic logs to technical support.
- IS200BPPBH2BMD
- IS200BPPBH2BMD
Frequently Asked Questions
Q: What is the IS200BPPBH2BMD used for?
A: It is a GE Mark VI board used in turbine control and analog I/O processing applications.
Q: Is this part still manufactured?
A: No, it is a legacy part and usually sold as surplus or refurbished stock.
Q: Can I replace it with a similar Mark VI board?
A: Maybe, but I would not assume interchangeability. The suffix and board revision need to match the installed system.
Q: Is it hot-swappable?
A: No. Power down the system before removal unless the OEM procedure for your exact rack explicitly allows live replacement.
Q: Why is surplus cheaper than factory new?
A: Because it comes from excess inventory, decommissioned equipment, or recovered stock. The lower price should always come with clear condition and testing details.
Q: What should I check before ordering?
A: Confirm the full part number, suffix, rack compatibility, and system revision. That avoids the common mistake of buying a near-match that does not work in the field.
